LKst-IIB、LKst-2000、LKst-2000BCarving machine operation sequence

1. The machine power line plug power source operation, according to the power switch, the switch red candle is bright, namely the power source puts through. 2. When presses the button, first should modulate velocity switch from Guan Zhizui slightly, again presses the button, should have "pa" the sound, explained the relay attracts gathers, the simultaneous working green light is bright. 3. The board enters the handle, loads the shaft lever the main axle, lightly turns on lathe to front, again lightly pulls to outside, after confirmed the shaft lever is cancelled by the tension bar, the pine operates the handle, the machine may start to revolve. 4. According to clockwise slowly gyrates the velocity modulation switch, the machine starts to rotate, transfers to the rotational speed voltage which needs, the machine constant speed revolution, then carries on the carving. 5. According to the height fast regulating cock, to the low time rotational speed is 0 □9,000 revolutions/The minute, transfers to must be 0----12000 revolution/The minute, ST----2000 and ST----2000B incomparably opens a hall, rotational speed directly from 0---12000 revolution/Duty-bound velocity modulation. 6. Like has the unusual situation, may step on treadons opens a hall, machine immediately knock off. After treats removes operates again according to the above order.